two and a half inch boiler steam hose supplier

  • Offshore price : $20000-$100000 Get a quote on the right form
  • Minimum order quantity : 1 set :two and a half inch boiler steam hose supplier
  • Supply Capacity : 10 units/month :two and a half inch boiler steam hose supplier
  • Manufacturer/Brand : Fangkuai boiler
  • Port : Anyang
  • payment terms : Letter of Credit, Wire Transfer, VISA

Leave Your Message And Get Price!

I need the quotation of , the fuel is , this capacity is , use for . My Name is , my Email is , my WhatsApp is , Please Send the detail information for me!

Popular products


θrion Gas Fired Steam Boiler


Rated thermal efficiency: 100-104%

Fixed working pressure: ≤1.6MPa

Applicable fuel:natural gas etc.


Gas(oil) Fired Integrated Hot Water Boiler


Rated thermal efficiency:96-98%

Fixed working pressure:≤1.25MPa

Applicable fuel:Natural gas, light oil, etc.


H6 Gas Fired Hot Water Boiler


Rated thermal efficiency: 97.2-106%

Fixed working pressure:0.1MPa

Applicable fuel:Natural gas, etc.


T7 Vacuum Hot Water Boilerr


Rated thermal efficiency:≥105.5%

Fixed working pressure:-0.02MPa

Applicable fuel:Natural gas, etc.


V6 Gas Fired Hot Water Boiler


Rated thermal efficiency:97.2-104.4%

Fixed working pressure:1.0MPa

Applicable fuel:Natural gas, etc.


Electric Steam Boiler

Capacity:0.5-4.0 t/h

Rated thermal efficiency:98%

Fixed working pressure:≤1.25MPa

Applicable fuel:electric energy


Leave us a message

We will send out plans and quotations within five minutes

Name (optional)



Choose product type



Get display discount

Contact us

Global Sales Hotline:

Email: [email protected]

  • Boiler Drum Level Control by Using Wide Open Control with

    Key word: Boiler drum, three elements, feed water flow, steam flow and water level in drum. 1. Introduction The control system for a boiler–turbine unit usually needs to meet therequirement of t he amount of water in the steam drum must be maintained at a desired level to prevent overheating of the drum or flooding of steam lines.Get Price

  • MnTAP – Steam Systems

    Steam is used to heat raw materials and treat semi-finished products. It is also a power source for equipment, as well as for building heat and electricity generation. But steam is not free. It costs approximately $18 billion (1997 dollars) annually to feed the boilers generating the steam. In terms of increasing the efficiency of your steam Get Price

  • undamaged and it did not take us long to get the walls of

    inches. I set the float switch so it would only fill about one fourth full, and connected up a 3-inch steam boiler pop valve which I had in stock with a length of 2|-inch fire hose to a fire hydrant, never know-ing whether this tank would stay up or not. The valve I set at 50 pounds blow-off. The next morning I called up the Chicago Bridge and Get Price

  • Steam Engine Development Timeline | Preceden

    Papin builds the first small working model of a steam engine and the first theoretical steam engine ever created standing just two and a half inches tall. 1816 Added high pressure and low pressure engines and developed insulated engines, pipes, and boilers for improved efficiency. Thomas Savery 1698 Savery builds the first primitive steam Get Price

  • Collinwood's Hardest Lesson: The Lake View School Fire

    fired boilers that circulated steam through insulated pipes to cast iron radiators, some located throughout the building and some in the venti-lation shafts providing the build-ing's air circulation. The primary exits were two separate, winding stairwells 5 feet (1.5 meters) wide on the east and west sides that discharged onGet Price

  • 20-3208-1 | MTH ELECTRIC TRAINS

    Named simply "999," the engine exuded class. Her hand-polished russian iron boiler was highlighted with shining brass trim and piping; her gleaming cab was fashioned of mahogany and maple; and the name of her train was emblazoned boldly on her tender in two-and-a-half-foot-high gold leaf lettering: "Empire State Express."Get Price

  • BSPT - Stevenson Plumbing and Electrical Supplies

    7/8 Inch BSP - Outlet thread on 3/4 inch outside tap (we have a brass tap connector for this size). 1 Inch BSP - Domestic heating boilers and hot water cylinders, urinal flush valves. 1-1/4 Inch BSP - Wash hand basin wastes (bathroom sink). 1-1/2 Inch BSP - Kitchen sink wastes, bath wastes, toilet syphon outlets, central heating pumps.Get Price


    The brittle break-up deposit removal criteria for thin layer of deposit strongly attached to a boiler tube is PJet Stensile ν ν 1 2 1 The jet power required to remove thick deposit with ν= 0.2 is two and a half times higher than that of thin deposit. (typically 10 inch as seen in Figure 8). In this case, the deposit located deep Get Price

  • Seymour, Sabin & Co. - History |

    Engine and boiler room. The vast field of machinery described in the foregoing article is kept in motion by two engines, located in an engine room 30x45 feet. The larger of the two is an Allis-Corliss, with a twenty-six inch cylinder and forty-eight …Get Price

  • The Best Gas Water Heater Options for the Home - Bob Vila

    Dec 22, 2020 · This combi boiler from Rheem boasts a 9.9 GPM output capacity that can satisfy the hot water demands of a home with up to two and a half bathrooms while using the least amount of energy possible Get Price

  • Steam Pipes and Other Causes of Fires in Manufacturing

    A steam pipe two and a half inches in diameter, for conveying the steam to the mill, passed through the wall of the boiler house, then ran perpendicularly to …Get Price

  • Donisthorpe Colliery - Northern Mine Research Society

    The control desk at each location was located in a control cabin. Boilers – Steam was provided by five Lancashire boilers working at 80 psi., and fitted with superheaters. In later years the boilers were fired by Danks's chain grate mechanical stokers in …Get Price

  • TE Connectivity Saves Therms & Dollars With Thermaxx

    Along with the steam traps and gate valves, Thermaxx also covered a large "Smith" boiler door which had a diameter of six and a half feet. Finally, we insulated all the steam piping that had been either previously been uninsulated or was damaged and needed replacement. There was roughly six hundred feet of pipe insulation including two Get Price

  • System 2000 leaks | Terry Love Plumbing Advice & Remodel

    Jul 05, 2018 · Much to my surprise my two and a half year old system 2000 boiler has a couple of leaks. One is coming from the overflow valve at the top of the hot water tank, and the other is coming from a part that sits on top of the boiler. I took it's lettering down, it is called a " WATTS BACKFLOW PREVENTER 1/2'' 9D-M3 with intermediate Atmos. vent".Get Price

  • Steam Boiler & Hot Water Supplies & Replacement Parts

    Steam Hoses - Grainger Industrial SupplyGet Price

  • Pipes and Pipe Sizing | Spirax Sarco

    Consider the system shown in Figure 10.2.6, and determine the pipe size required from the boiler to the unit heater branch line. Unit heater steam load = 270 kg/h. Although the unit heater only requires 270 kg/h, the boiler has to supply more than this due to heat losses from the pipe. The allowance for pipe fittingsGet Price

  • The Design and Construction of Railway Shops

    Two tracks should run the whole length of the work, with frequent cross-over switches and connection to the transfer table in boiler and erecting shops, if such is used: and by the simple precaution, in first laying out the shops, of establishing the floor levels two feet above the mean out-door level, which will ensure dry ground around the Get Price

  • Old Boilers and Old Men - Mr. Beller's Neighborhood

    Jan 20, 2003 · It was a 110 year-old manual coal fed steam boiler, retrofitted to work with all this fancy natural gas and running water. four and a half feet of 2 inch pipe. Seven 2 to 1 _ inch reducers. Seven six inch copper nipples. had to stay behind for two hours, with a hose and a shovel, helping the police put his pal into a garbage bag. So Get Price

7X24 Online